Emergency Repairs (Monday - Saturday)
Call Now →
Free QuoteServices
Repiping Services

Whole Home Repiping in Coon Rapids, MN

If your water pressure has been dropping for no clear reason, or you're finding rust-colored water when you first turn on a faucet, your supply lines may be the problem, not your water heater or your fixtures. Flowmaster Plumbing repipes homes throughout Coon Rapids and the surrounding Anoka County suburbs, replacing old and failing pipe with copper or PEX systems built to last.

Get Started Today

Free estimates · Fast response · No pressure

By submitting this form, you agree to be contacted by Flow Master Plumbing regarding your inquiry.

★★★★★ 4.9 Google★★★★★ 5.0 Facebook
Thank you! Your submission has been received!
Oops! Something went wrong while submitting the form.
New copper and PEX supply lines during a whole home repipe in Coon Rapids, MN
SK
Sarah K.
★★★★★
"Flow Master came out same day and fixed my problem fast."

Signs Your Home Needs Repiping

A few problems tend to show up together when supply lines are wearing out:

  • Low water pressure, especially noticeable when two fixtures run at once
  • Discolored or rusty water, particularly right after the water's been sitting overnight
  • Frequent pinhole leaks that keep popping up in different spots along the same line
  • Visible corrosion, flaking, or pitting on any exposed pipe in the basement or utility areas

One of these on its own might just need a repair. A few of these together, on a house with original piping, usually means the pipe itself has reached the end of its usable life.

Why This Is So Common in Coon Rapids

A lot of homes across the older sections of Coon Rapids and neighboring Anoka County suburbs were built between the 1960s and 1980s with galvanized steel supply lines. That pipe has an expected service life, and most of it around here is well past it at this point. Corrosion builds up on the inside of the pipe over decades, narrowing the diameter and shedding rust into the water supply. It's the single biggest driver of repiping calls we get in this area. Some homes from the 1970s and 80s also have polybutylene piping, which was popular at the time but is known to fail at the fittings. If your house falls into either of these categories, it's worth having it looked at even if things seem fine right now.

Copper vs. PEX: Which Is Right for Your Home

Both are solid options and we install either one depending on your home and your priorities.

Copper has been the standard for decades. It handles heat well, holds up to UV exposure if it's ever exposed, and has a long track record. It costs more in materials and labor because it has to be soldered.

PEX is flexible, resists freezing better than rigid pipe, and can be run with fewer joints, which means fewer potential leak points. It installs faster, which usually means lower labor cost.

Neither is a wrong answer for most homes. We'll tell you which one fits your situation, your water heater setup, and your budget when we quote the job.

Why Choose Flowmaster Plumbing

Flowmaster Plumbing is locally owned and owner-operated by Yuriy Timoshenko, based right here in Coon Rapids. A few things that matter when you're deciding who opens up your walls:

  • BBB accredited with an A- rating
  • Licensed and insured for the work we do
  • Upfront pricing — you get a number before we start, not a surprise after
  • Satisfaction guarantee on our workmanship

We're a newer company in this market, and we know that means something to some homeowners. What we offer instead of a long history is direct accountability. Yuriy is the one on your job, and the guarantee, license, and BBB accreditation are there to back that up.

Get Started Today

Free estimates · Fast response · No pressure

By submitting this form, you agree to be contacted by Flow Master Plumbing regarding your inquiry.

★★★★★ 4.9 Google★★★★★ 5.0 Facebook
Thank you! Your submission has been received!
Oops! Something went wrong while submitting the form.
Our Process

Our Repiping Process

Every repipe starts with a walkthrough. We look at what's accessible, what's behind walls or under slab, and map out the most direct path to get new lines to every fixture with the least amount of drywall disruption possible.

From there:

  1. Assessment and quote. We identify pipe material, condition, and access points, then give you a clear, upfront price before anything is cut into.
  2. Access and routing. We open the minimum amount of wall or ceiling needed to run new lines, working room by room to keep water shut off time short.
  3. Installation. New supply lines are run, pressure tested, and connected to fixtures.
  4. Patch and cleanup. We coordinate access points so drywall repair is straightforward, and we leave the work area clean.

Timelines vary by house size and how much is behind finished walls, but most whole-home repipes are planned out in phases so you're not without water for long stretches. We'll give you a realistic timeframe during the quote, not a guess.

FAQs

Questions We Hear Most

How long does a whole-home repipe take?

It depends on the size of the home and how much pipe is behind finished walls, but most projects are completed in a matter of days, often broken into phases to limit how long water is shut off in any one area. We'll give you a specific estimate during your quote.

Do I need to move out during repiping?

Most homeowners stay in the house during the work. We phase the job area by area so you still have water access to at least part of the home most of the time.

Is copper or PEX better for my house?

Both are reliable choices. Copper has a longer track record and handles heat well; PEX is flexible, resists freezing, and typically costs less to install. We'll recommend one based on your home's layout and your budget.

How do I know if I have galvanized steel pipe?

If your home was built before the 1990s and you haven't had the plumbing updated, there's a good chance you still have original galvanized lines. Signs include rust-colored water, dropping pressure over time, and visible corrosion on any exposed pipe. We can confirm it during an inspection.

Will repiping damage my walls?

We open the minimum access needed to route new lines and coordinate the work so drywall repair afterward is straightforward. It's part of the job, and we plan the routing to keep that disruption as limited as possible.

Rusty water and dropping pressure don't fix themselves, and they tend to get worse the longer old pipe sits in the walls. Call (612) 461-7966 or request a quote and schedule service online and Yuriy will get eyes on your plumbing and give you a straight answer on what it needs.

Service Area

Based in Anoka County, Serving the Twin Cities

Flowmaster Plumbing is based in Coon Rapids and serves homeowners and light commercial customers throughout Anoka County and the Twin Cities metro. If you're inside this map, you're inside our service area.

Coon Rapids
Blaine
Andover
Anoka
Champlin
Ramsey
Fridley
Spring Lake Park
Brooklyn Park
Minneapolis
St. Paul
Contact the Crew That Knows What to Do

Quality You Can Trust, With Prices You Can Afford

Let's get your plumbing back on track. Fast response, honest pricing, done right the first time.

Flow Master Plumbing mascot